This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 19 (click to view)
STABILITY BRACKET
To reduce the risk of the appliance tipping due to improper use or door loading, it must be securely installed using the stability bracket supplied. 1. Place the stability bracket on the floor as shown in figure 2. If there is no side wall, the dimension given as 0.5 cm will be the distance of the left / right side of the appliance to left / right of the stability bracket. If there is a side wall, the dimension given as 2.5 cm will be the distance of the left / right side of the stability bracket to the side wall. If your appliance is 50 cm wide, the distance between the back wall and the top edge plate should be zero. If your appliance is 60 cm wide, the distance between the back wall and top edge plate should be 2 cm. Mark the locations of the 2 holes of the stability bracket on the floor. Use a 7.5mm masonry drill bit to make the holes and insert the plastic anchor. Secure the bracket to the floor using the screws supplied. Slide the appliance into place (Figure 1).